On this page
Asset Type
Manufacturer
Model
What This Guide Helps With
REV ORIENT error preventing Flex/Reflex movement due to table orientation mismatch, stopping position changes during surgical positioning.
Step-by-Step Troubleshooting
1. Ensure Patient Safety First
- Stop all table movement if currently in use
- Ensure patient is stable and secure
- Do not attempt repositioning during active procedures
2. Verify the Reported Error and Behavior
- Attempt Flex or Reflex positioning
- Check for “REV ORIENT” message on screen
- Observe if movement is restricted
- Confirm other table functions operate normally
3. Check Table Orientation Status
- Observe patient orientation relative to the base
- Check orientation indicator on display (if available)
- Determine if table was recently rotated or repositioned
4. Correct the Orientation Setting
- Press the Reverse Orientation (REV ORIENT) control button
- Return the table to normal orientation
- Retry Flex/Reflex movement
5. Check for Simultaneous Control Input
- Use only one control device (hand control preferred)
- Ensure no buttons are stuck or pressed at the same time
- Eliminate conflicting inputs
6. Verify Resolution
- Confirm Flex/Reflex functions operate normally
- Test multiple table movements
- Return table to service if functioning correctly
If the Problem Persists
If the REV ORIENT error continues after confirming correct orientation and proper control use, external causes have been ruled out.
- Remove the table from service
- Label the device as Out of Service
- Send for repair or bench evaluation
Persistent issues may indicate control system faults, orientation sensor issues, or internal communication failures.
Clinical Use Tip
Never troubleshoot table positioning issues on an active patient. Always move the patient to a backup device before performing diagnostics.
Work Order Documentation (CCR Method)
CCR = Complaint, Cause, Resolution
Complaint
What was reported by the clinical staff.
Example:
"Table displaying REV ORIENT error and unable to perform Flex/Reflex positioning."
Cause
What was observed during troubleshooting.
Example:
"Table was in reverse orientation, preventing Flex/Reflex movement per system logic."
Resolution
What action was taken.
Example:
"Pressed Reverse Orientation control, restored normal orientation, and verified full functionality."
Helpful Details to Include (If Known)
- Alarm behavior
- Accessories swapped
- Power behavior
- Environmental factors
- Indicator lights
- Final device status
Final Thought
Understanding system logic behind orientation-related errors prevents unnecessary part replacement. Always verify orientation and control inputs before escalating. Proper troubleshooting ensures safe operation and efficient workflow.
That is successful troubleshooting.